Sounds like a marketing exercise at this point in time, as obvously its not cost effective for the average Joe to do prior to failure. But in a couple years as the motors start to go pop, they will have the upgraded parts ready to ship.
I like the list of cars they have built motors for over the last decade…RS4s, S5s…
^^^where’;d you see that? I saw that they took apart some motors
[quote] We have taken apart every motor worth building for the A3/A4/S4/RS4/A5/S5/A6/S6 during the last decade
[/quote]
Never mind that was it. I was just scanning and misread it. So everything they haven’t built wasn’t worth it I guess.
I have nothing to share, David posted this over on Audizine. It would most likely be best to ask him the questions over there.
[quote=“500HPS5,post:11,topic:4826”]
Understood… I’ll follow the thread but won’t be posting on vendorzine…
[quote=“primetime,post:12,topic:4826”]
Shoot him an email Ron, or call him. david@ecodetuning.com 310-294-8108
[quote=“500HPS5,post:13,topic:4826”]
maybe you can hvae him sign up overe here. Its a more friendly enviremenet the AZ and we have a lot of guys here that are going to want to know more without clogging up the thread on AZ.
looks interesting. Eurocode can be the AWE of the 3.0T if they do this right. AWE made a big break out with the silver bulit maybe eurocode can do that with the project they have. with the growing 3.0 membership here I think this would be the fist polace to think to start the thread
[quote=“ChrisK,post:14,topic:4826”]
Its better to keep the discussion here, and marketing over there. Both serve their purposes.
will be expensive, will still under perform, and will run on hopes and dreams…why?
Because it is an audi
^^^you buy a Porsche or something? Finally get your dreamcar? 
[quote=“91gl,post:16,topic:4826”]
will be expensive, will still under perform, and will run on hopes and dreams…why?
Because it is an audi
Found this guy posted on Euro Codes FB page last night.
Never seen a picture of the NOS setup before, thought it was interesting.
https://scontent-b-sea.xx.fbcdn.net/hphotos-prn2/t31/1899257_10152267756164429_1133906296_o.jpg
I thought I’ve seen the pic before somewhere but could be wrong… Looks like the plates they made for plasticbags buddy… He was running juice so I’m assuming it was this or similar? Speaking of paperbag, ah nevermind…
If your doing a nitrous kit… that fogger set up look nice
They are using the separate fan spray nozzles, not the fogger…? I thought they were using a fogger nozzle, would have been cleaner looking in the flow path, fogger2 comes 90 degrees.
bet that looked pretty crazy all squeezed in there
Those are the shark nozzles I don’t know why they wouldn’t use the single mix nozzle. It looks nice but it is cluttered
Because they have no sense or understanding of the system.
That is a very similar setup to the one I have been working on. I plan on installing it before the summer as long as the tuning goes well…
I honestly believe this might be the ticket to 10s… If she stays together, stock internals that is 
Can’t wait to see Eurocode finish this project! !
Ad
That project is dead, it’s from a customers car (the ghost )
Wth? Goes to show you how much time I spend on the forums.
Appreciate the update, so wtf happened, in short?
Ad