Did you ever get those pictures I’m stumped
So look below where the bigger tube ‘‘twists’’
That definitely helps I’m about to go back and take a look
From what I see here I think it’s the last hose on the back that’s coming upwards on your last picture…
The one on top with the blue writing?
It was! Thanks for your help!
1 Like
It starts! And sounds better than ever. I do have a question, would the coolant that leaked out on the exhaust manifold make a smoke screen?
Yes. Spy hunter style
1 Like
That clears that up haha
Really been watching this thread as I’m pretty much in the exact same spot. Just finished VC gaskets and am about to get the manny off as soon as I can carve out another full day. Robo, I just have one question though as I’ve been following this thread - whatever happened with that rocker arm?
I took all the pieces out and of course it’s misfiring because of it but I’m going to have the engine dropped at this point
Gotcha - are you still planning on driving it or are you already starting to plan for a drop? Even with that loose arm removed - I would imagine a misfire alone would be at the low end of concern. How detrimental does this group suppose continuing to drive will be to the life of the engine?
I’m unsure honestly. I have an extended warranty that I just started and I think if it comes down to it I could get a newer engine. But until then I’ll take a few trips around town and get it up to operating temp a few times
Ok the passenger side fuel line that leads to the fuel rail under the manifold is leaking (the thicker line) my crows foot wrench from harbor freight couldn’t reach and tighten it much. What should I do because I’m now tired of the gas smell
Update: I got the fuel line as tight as possible that I could do without a wrench it doesn’t leak anymore which is a plus and the cold starts sound pretty good It takes 2 or so seconds and runs like 
for the first 6 or so seconds and stays at a solid 758 rpm and has a slow acceleration in 1st until you hit 3600 rpm. Once it’s warmed up it’s much more lively.
Good to hear it man! I’m right behind you with the manifold. Have only a few things left, fuel lines mainly. Hoping I can get it off by tomorrow and start cleaning.
1 Like
Robocop.
Just to re cap. Your lifters are still broken or just the arms are not there on 2 cylinders correct.
All of the cars good condition or not are going to missfre if you have your SAI still and the temps get cold enough on cold start. So I wouldn’t worry much about that. Also the cars tend to missfire if the ECU is adapting.
2/40 rocker arms broke and I saw the sai delete on jhm seeing it was one of the cheaper things on their website. I’ll look into that